| If
you have more than four cameras in your surveillance system,
then you know that the ease of "scanning" between cameras
is a little tricky. You have to manually turn off one
camera, then turn on the next camera. It wasn't as easy
to scan 4 cameras as 8 cameras! Now you can get a NEW
smart solution to multi-camera scanning! Now you can push
one button and scan among all the cameras in your system,
whether you have 4 or 16! Its the answer you've been looking
for!
How
it works: The default setting for the remote
is to control 1 group of four cameras. To set it to scan
through more than four cameras, the customer has to configure
the number of cameras. This
is easy to do: First, slide the switch at the bottom of
the remote to "Program" (See photo on left.) and hold
down the button corresponding to the total number of cameras
(if 6 cameras, button 6) (the LED will blink to indicate
that the change is made) then slide the switch back to
"Normal" while still holding down the button.
Now the scan button will work for all the cameras configured.
  .Because the 4 camera groups built into the addressable
power supplies (XM10A) remain unchanged, the "ScanPower"
Director sends
off commands to accomplish the scanning function. This
means that when changing cameras outside of one of the
camera groups (group 1: Cameras 1-4; Group 2: Cameras
5-8, etc.), it will take a couple seconds for the "ScanPower"
Director to send all
the necessary commands.
|